Marantz SR5005 SR5005 User Manual - English - Page 10

Simple version Basic version SVENSKA NEDERLANDS ESPAÑOL ITALIANO FRANÇAIS DEUTSCH ENGLISH Set up speakers (Audyssey® Auto Setup) About setup microphone placement • Measurements are performed by placing the setup microphone successively at multiple positions throughout the entire listening area, as shown in GExample qH. For best results, we recommend you measure in six positions, as shown in the illustration (up to six positions). • Even if the listening environment is small as shown in GExample wH, measuring at multiple points throughout the listening environment results in more effective correction. GExample qH FL SW C FR GExample wH FL SW C FR 1 Set up the microphone Mount the setup microphone on a tripod or stand and place it in the main listening position. When placing the setup microphone, adjust the height of the sound receptor to the level of the listener's ear. Sound receptor Setup microphone 3 Set up the remote control unit nn Set up the operation mode Press AMP to set the remote control unit to amplifier operation mode. ( : Measuring positions) ( : Measuring positions) Press AMP SL *M SBL SBR FL Front speaker (L) FR Front speaker (R) C Center speaker SW Subwoofer SR SL *M SR SBL SBR SL Surround speaker (L) SR Surround speaker (R) SBL Surround back speaker (L) SBR Surround back speaker (R) About the main listening position (*M) The main listening position is the position where listeners would normally sit or where one would normally sit alone within the listening environment. Before starting Audyssey Auto Setup, place the setup microphone in the main listening position. Audyssey MultEQ® uses the measurements from this position to calculate speaker distance, level, polarity, and the optimum crossover value for the subwoofer. NOTE • Do not hold the setup microphone in your hand during measurements. • Avoid placing the setup microphone close to a seat back or wall as sound reflections may give inaccurate results. 2 Set up the subwoofer If using a subwoofer capable of the following adjustments, set up the subwoofer as shown below. nn When using a subwoofer with a direct mode Set the direct mode to "On" and disable the volume adjustment and crossover frequency setting. nn When using a subwoofer without a direct mode Make the following settings: • Volume : "12 o'clock position" • Crossover frequency : "Maximum/Highest Frequency" • Low pass filter : "Off" • Standby mode : "Off" Advanced version Information The "Simple version" section provides the speaker installation, connection, and setup methods for the 7.1-channel system with surround back speakers. 7 For the installing, connecting, and setup methods of speakers other than the 7.1-channel system (with surround back speakers), see page 33.