Marantz SR5005 SR5005 User Manual - English - Page 67
Programming with the 4-digit code, Scanning the code table, Checking the code, Resetting the code
View all Marantz SR5005 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
ENGLISH DEUTSCH FRANÇAIS nnProgramming with the 4-digit code 1 Press and hold down the input source select buttons for the appliance to control, and press SET until the SEND indicator blinks twice. The back light flashes. 2 Press the 4-digit code for the appliance using the numeric buttons (code table at the end of this book). When the procedure is successful, the SEND indicator blinks twice. NOTE If the indicator did not blink twice, then repeat steps 1 and 2 and try entering the same code again. nnScanning the code table 1 Switch on the appliance to control. 2 Press and hold down the input source select buttons for the appliance to control, and press SET until the SEND indicator blinks twice. The back light flashes. 3 Aim the remote control at the appliance and slowly alternate between pressing INPUT d and SOURCE ON/OFF for the appliance. 4 Stop when the appliance turns off. 5 Press ENTER once to lock in the code. ITALIANO ESPAÑOL NEDERLANDS nnChecking the code 1 Press and hold down the input source select buttons for appliance to control, and press SET until the SEND indicator blinks twice and back light flashes. The back light flashes. 2 Press SEARCH/INFO. The SEND indicator blinks twice. 3 To view the code for first digit, press 1 once. Count the number of times the SEND indicator blinks (e.g. 3 blinks = 3) and write down the number. 4 Then press 2 to check the second digit of the code. Now press 3 and 4 to check the third and fourth digits of the code. NOTE If a code digit is "0", the SEND indicator does not blink. SVENSKA Registering preset codes nnResetting the code The devices shown below are registered for each input source button as default. Settings can be changed according to the devices to be used. 1 Press and hold down the input source select buttons for appliance to control and press SET until the SEND indicator blinks twice. The back light flashes. 2 Press the codes below to reset the code. The indicator will blink twice. Input source select buttons Category Blu-ray Disc player Preset code 5000 DVD player 2000 Television 1000 Satellite set top box 4000 CD player 3000 NOTE After this procedure, the selected source reset to its initial code. 64