Marantz SR5005 SR5005 User Manual - English - Page 69
Operating learn mode
View all Marantz SR5005 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
ENGLISH DEUTSCH FRANÇAIS ITALIANO ESPAÑOL NEDERLANDS SVENSKA Operating learn mode This remote control unit is capable of learning and storing codes used by other remote controls that you already own. For codes which are not learned, the remote control unit will transmit either the Marantz preset codes from the initial settings, or remote codes from another manufacturer's AV equipment which is set by the customer. The receiver sensor for the remote control unit signals is located at the top of the remote control unit. This remote control unit is capable of learning around 160 codes. NOTE The learning procedure does not operate correctly if the batteries have become worn. nnLearning procedure 1 Place the Marantz remote control and remote control from the other device approximately 5 cm apart, with the remote control signal transmission sections facing each other. 5 cm 2 Press and hold down SET and SOURCE SEL until the LEARN indicator blinks. 3 Press input source select buttons to select the input source. 4 Select the button to be learned. LEARN indicator lights up. NOTE • The learning function is unavailable for all SOURCE and D.MODE in any mode. • The learning function is unavailable for all buttons in TUNER mode and AMP mode. 5 Press and hold the button of the original remote control unit to be learned until the SEND indicator blinks twice. NOTE • If the SEND indicator blinks once, repeat this step. • If the LEARN indicator flashes when the SEND indicator is lit, then the button cannot be learned. • When the memory of the remote control unit is full, the LEARN and SEND indicators blink once. If you want to learn the code, you need to erase a different learned button. 6 Repeat steps 4 and 5 to learn other buttons for the same input source. 7 Repeat steps 3 to 6 to learn other input sources. 8 When programming of the remote control unit is completed, press SET. The LEARN display disappears, and the remote control unit exits learn mode. NOTE • When the SEND indicator blinks once again, the transmitting code is unavailable for remote control unit, or the transmitting signal has been interrupted by noise. • If no buttons are pressed for approximately 1 minutes while in the LEARN mode, the remote control unit automatically exits from the LEARN mode. nnErasing programmed codes Codes can be erased in three ways: by buttons, sources, and by all memory contents. Erasing the code by buttons 1 Press and hold down SET and SOURCE SEL until the LEARN indicator blinks. 2 Press input source select buttons to select the input source you want to delete. 3 Press and hold down D.MODE and press the learned button to be erased twice. SEND indicator blinks twice and the mode returns to LEARN mode. 4 To return the normal mode, press SET. Erasing the code by SOURCE 1 Press and hold down SET and SOURCE SEL until the LEARN indicator blinks. 2 Press and hold down D.MODE and press the learned input source select buttons to be erased twice. LEARN indicator lights. 3 Press ENTER to continue erasing. • The SEND indicator blinks twice and the mode returns to LEARN mode. • To cancel the erasing operation, do not press ENTER, and simply press any other button. 4 To return the normal mode, press SET. 66