Marantz SR5005 SR5005 User Manual - English - Page 56
Audyssey Settings
View all Marantz SR5005 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Simple version Basic version SVENSKA NEDERLANDS ESPAÑOL ITALIANO FRANÇAIS DEUTSCH ENGLISH Setting items Height Gain Control the front height channel volume. Setting details Low : Reduce the front height channel volume. Mid : Front height channel sound is output with standard sound volume. High : Increase the front height channel volume. Default The "Surround Parameter" settings are returned to the default settings. NOTE "Height Gain" is displayed for the following settings. • When "Amp Assign" (vpage 56) is set to "Normal". • When the "Speaker Config." - "Front Height" setting (vpage 57) is set to other than "None". • When surround mode is "PLgz" or the PLgz decoder is used. Yes : Reset to the defaults. No : Do not reset to the defaults. Tone Default settings are underlined. Adjust the tonal quality of the sound. Setting items Setting details Tone Control ON : Allow tone adjustment (bass, treble). Set the tone control function OFF : Playback without tone adjustment. to ON and OFF. "Tone Control" can be set when "Dynamic EQ" (vpage 54) is set to "OFF". NOTE The tone cannot be adjusted in the direct mode. Bass -6dB - +6dB (0dB) Adjust low frequency range (bass). "Bass" can be set when "Tone Control" is set to "ON". Treble -6dB - +6dB (0dB) Adjust high frequency range (treble). "Treble" can be set when "Tone Control" is set to "ON". Audio Adjust Audyssey Settings Default settings are underlined. Set MultEQ®, Dynamic EQ® and Dynamic Volume®. These can be selected after Audyssey® Auto Setup has been performed. For additional information on Audyssey technology, please see page 78. NOTE If you have not performed Auto Setup, or if you change the speaker settings after performing Auto Setup, you may not be able to select Dynamic EQ/Dynamic Volume, and "Run Audyssey" may be displayed. In this case, either perform Audyssey Auto Setup over again or perform "Restore" (vpage 10) to return to the settings after Audyssey Auto Setup was run. Setting items MultEQ Select one equalizer from three modes. MultEQ corrects both time and frequency response problems in the listening area based on Audyssey Auto Setup calibration. We recommend "Audyssey". MultEQ is the prerequisite function for Dynamic EQ and Dynamic Volume. Setting details Audyssey : Optimize the frequency response of all speakers. Audyssey Byp.L/R : Optimize frequency response of speakers except front L and R speakers. Audyssey Flat : Optimize frequency response of all speakers to flat response. Manual : Apply frequency response set with "Manual EQ" (vpage 55). OFF : Turn "MultEQ" equalizer off. • "Audyssey", "Audyssey Byp. L/R" and "Audyssey Flat" can be selected after Audyssey Auto Setup has been performed. "Audyssey" is automatically selected after performing Audyssey Auto Setup. When "Audyssey", "Audyssey Byp. L/R" or "Audyssey Flat" is selected, illuminates. • After running Audyssey Auto Setup, if the Speaker Configuration, Distance, Channel Level, and Crossover Freq. have changed without increasing the number of speakers measured, only illuminates. • Press MULTEQ on the remote control unit to set this setting. NOTE • "MultEQ" and "Manual" cannot be selected when "EQ Customize" is set to "Not Used" (vpage 59). • When using headphones, "MultEQ" is automatically set to "OFF". Advanced version Information Remote control operation buttons Move the cursor (Up/Down/Left/Right) Confirm the setting Return to previous menu 53