Oki ML490 Network User's Guide for OkiLAN 6120i - Page 99

Section 4 - Chapter 1 - Introduction Network Preparation • You should be familiar with network administration as well as the physical setup and operation of your network. • Advise users of possible disruption during installation. • Make sure the serial number and Ethernet address of your OkiLAN 6120i are available. • Assign an IP address and a hostname (alias) to the OkiLAN 6120i. Use the network name service or the "/etc/hosts" file to add the OkiLAN 6120i to the network. Before You Start Before running OkiNet for TCP/IP, you must do the following: • Install the OkiLAN 6120i hardware and connect the cabling (if necessary). Instructions for hardware installation are found in Section I of this manual. • Write down the serial number and Ethernet address of your OkiLAN 6120i. (These numbers are located on the OkiLAN 6120i unit.) • Install OkiNet for TCP/IP-see Section I. Overview of TCP/IP Configuration • Assign an IP address for the OkiLAN 6120e • Configure the OkiLAN 6120e network information • Configure hosts for printing to the OkiLAN 6120e • Test print (optional) IV - 6 OKI OkiLAN 6120i User's Guide