Panasonic AW-RP150GJ AW-RP150 Operation Manual - Operating Instructions - Page 14

Parts and their functions (continued) Rear panel  GPIO 2 TALLY/GPIO 1 SIGNAL GND 3G SDI ACTIVE IN 5 THRU OUT SERIAL CONT 4 3 2 POWER ON IP CONT 1 LINK ACT 12V IN      POWER switch [POWER] When the POWER switch is set to the ON position, the POWER indicator (1) lights, and the unit can be operated.  SERIAL CONT 1 to 5 connectors [SERIAL CONT 1 to 5] (RJ‑45) Connect remote cameras that support a serial connection to these connectors with LAN cables. Connect them with straight cables (category 5e or better shielded cable). For details, refer to "Connections" (pages 16 to 19). Note zzDo not connect cables for PoE+ power supply to these connectors.  IP CONT connector [IP CONT] (RJ‑45) (10BASE‑T/100BASE‑TX) Connect a remote camera or computer that supports an IP connection to this connector with a LAN cable. When directly connecting a device to the unit, use a crossover cable (category 5e or better shielded cable). When connecting via a hub (switching hub) etc., use a straight cable or a cross cable (category 5e cable). For details, refer to "Connections" (pages 16 to 19).  3G SDI terminal [3G SDI] Use to input and output HD SDI signals. zzWhen the power of the unit is off, signals are not output from the ACTIVE THRU OUT connector. For details, refer to "Connections" (pages 16 to 19).  TALLY/GPIO 1 connector [TALLY/GPIO 1] JST: JBY‑25S‑1A3F(LF)(SN) Connect an external device to this connector to receive tally information or send the camera selection status. Use a shielded cable to connect to the connector. RS-442 LAN    DC IN socket [12V IN] (DC 12 V) (XLR connector) Connect an external DC power supply to this connector. zzUse a DC cable with a length of max. 2 m (6.6 ft) (when using an AWG16 cable). „„External DC power supply Connect after making sure that the output voltage of the external DC power supply is compatible with the rated voltage of the camera. Select an output amperage for the external DC power supply with a margin above the total amperage of the connected devices. The total amperage of connected devices can be calculated with the following formula. Total power consumption ÷ voltage When the power of the camera is turned on, inrush current is generated. Insufficient power supply when turning on the power may cause a malfunction. We recommend that you use an external DC power supply that can assure double the capacity of the total power consumption of the camera and connected devices that are turned on by interlock when the power of the camera is turned on (such as lenses, wireless microphone receivers). zzMake sure of the pin alignment of the DC output terminal of the external DC power supply and the camera DC IN connector, and connect the polarity correctly. If the +12 V power supply is mistakenly connected to the GND terminal, it may cause fire or malfunction. 12V IN 1 GND 2- 1 2 3- 3 4 +12V 4 HA16RA-4P (77) Hirose Electric Co.  Grounding terminal [SIGNAL GND] Connect this to the system ground.  GPIO 2 connector [GPIO 2] JST: JBY‑25S‑1A3F(LF)(SN) Connect an external device to this connector to enable selection of cameras or perform preset playback. Use a shielded cable to connect to the connector. 14