Panasonic AW-RP150GJ AW-RP150 Operation Manual - Operating Instructions - Page 92
Specifications, General, Input/output connectors
View all Panasonic AW-RP150GJ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
Specifications Power supply: Current consumption: 12 V DC ( ) (10.8 V to 13.2 V) 42 V - 57 V DC ( ) (PoE+ power supply) 1 A (Power supply: 12 V DC) 0.6 A (PoE+ power supply) indicates safety information. General Ambient operating temperature: 0 °C to 40 °C (32 °F to 104 °F) Allowable humidity: 10% to 90% (no condensation) Weight: Approx. 3.2 kg (7.05 lb) Dimensions (W × H × D): 342 mm × 178 mm × 245 mm (13-15/32 inches × 7 inches × 9-21/32 inches) (excluding protrusions) The symbols on this product (including the accessories) represent the following: DC Input/output connectors DC 12 V IN (XLR 4‑pin) 3G SDI IN / 3G SDI ACTIVE THRU OUT: SMPTE292/75 Ω Supported formats: 1080/59.94p*, 1080/59.94i, 1080/23.98p, 1080/23.98PsF, 1080/50p*, 1080/50i, 1080/25p, 1080/25PsF *: Only Level A is supported IP CONT (RJ‑45): 10BASE‑T/100BASE‑TX PoE+ input Connection cable: LAN cable, max. 100 m (328 ft) zzWhen connecting the unit via a switching hub: Straight cable or a cross cable (category 5e cable), STP (Shielded Twisted Pair) cable recommended zzWhen connecting the unit directly: Crossover cable (category 5e cable), STP (Shielded Twisted Pair) cable recommended SERIAL CONT (RJ‑45): RS‑422 (control signals for remote cameras) Connecting cable: Straight cable (category 5e or better shielded cable), max. 1000 m (3280 ft) TALLY OUT: Open collector output (negative logic) Maximum voltage resistance DC 24 V, Maximum current 50 mA TALLY/GPIO 1 (D‑sub 25‑pin, female, inch thread): TALLY IN : 10 inputs (for receiving photocoupler signals) GPI : 6 inputs (for receiving photocoupler signals) GPIO : 5 inputs (for receiving photocoupler signals) or 5 outputs (open collector outputs, negative logic) zzInput/output switched with menu settings GPIO 2 (D‑sub 25‑pin, female, inch thread): GPI : 10 inputs (for receiving photocoupler signals) GPIO : 10 inputs (for receiving photocoupler signals) or 10 outputs (open collector outputs, negative logic) zzInput/output switched with menu settings Reserve connectors: 2 connectors (For future expansion feature) 92