Panasonic KXTG5212 KXTG5210 User Guide - Page 73

Preparation Telephone System Answering System Useful Information Troubleshooting If the handset display shows error messages, see "If the Following Appear on Your Display..." (p. 71-72) for the Cause & Remedy. Telephone System Problem "No link to base. Move closer to base and try again." is displayed and an alarm tone sounds. Static, sound cuts in/out, fades. Interference from other electrical units. The handset does not ring. The handset display is blank. You cannot program any function items. While programming or searching, the handset starts to ring and the program/ search stops. Cause & Remedy • The handset has lost communication with the base unit. Walk closer to the base unit, and try again. • Confirm the base unit's AC adaptor is plugged in. • Raise the base unit antennas. • The handset's registration may have been canceled. Re-register the handset (p. 69, 70). • Move the handset and base unit away from other electrical appliances (p. 6). • Walk closer to the base unit. • Raise the base unit antennas. • Turn on the Clarity Booster feature (p. 28). • The ringer volume is turned off. Set to high, medium, or low (p. 20). • If more than one other user is using the handset and/or base unit, the handset may not ring. Users will hear incoming call tones (p. 50). • If the handset display is blank, fully charge the battery (p. 13). • Programming is not possible while the handset and/or base unit is being used. • Do not pause for over 60 seconds while programming. • Walk closer to the base unit. • While another user is listening to messages or the Answering System is handling a call, you cannot program. Try again later. • A call is coming in. To answer the call, press [C] or [s]. Start again from the beginning after hanging up. For assistance, please call: 1-800-211-PANA(7262) 73