Panasonic PVDV953D Digital Video Camera - Page 13

Inserting the Button-type Battery, Using the Remote Controller

Page 13 highlights

1 1 2 3 ª Inserting the Button-type Battery Before using the remote controller, insert the supplied button-type battery. 1 While pressing the Stopper 1, pull out the Battery Holder. 2 Insert the button-type battery with the imprint (i) facing upward. 3 Insert the Battery Holder into the Remote Controller. ≥When the button-type battery becomes weak, replace it with a new CR2025 battery. (A battery is normally expected to last about one year. However, it depends on operation frequency.) ≥Be sure to match the poles properly when inserting the battery...Warning Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the equipment manufacturer. Discard used batteries according to manufacturer's instructions. Risk of fire, explosion and burns. Do not recharge, disassemble, heat above 212°F (100°C) or incinerate. Keep the Button-Type battery out of the reach of children. Never put Button-Type battery in mouth. If swallowed, call your doctor...Replace battery with Panasonic PART NO. CR2025 only. Use of another battery may present a risk of fire or explosion. Caution: Battery may explode if mistreated. Dispose of used battery promptly. Keep away from children. Do not recharge, disassemble or dispose of in fire. ª Using the Remote Controller 1 Direct the Remote Controller at the Remote Control Sensor on the Palmcorder and press the desired button. ≥Distance from the Palmcorder: Within approximately 15 feet (5 meters) ≥Angle: Within approximately 5o in the upward, and 15o in the downward and horizontal directions from the central axis 5˚ 1 15˚ 15˚ 15˚ ≥The above operating ranges are for indoor use. Outdoors, or under strong light, the equipment may not operate properly even within the above ranges. ≥Within 3 feet (1 meter) range, you can also use the Remote Controller on the side (the LCD Monitor side) of the Palmcorder. Selecting Remote Controller Modes When two Palmcorders are used simultaneously, they can be operated START/ DATE/ PHOTO STOP OSD TIME SHOT individually by selecting different Remote Controller Modes. ≥If the Remote Controller Mode on the Palmcorder and Remote Controller do COUNTER RESET TITLE ZOOM not match, [REMOTE] is displayed. T MULTI/ P-IN-P ¥REC A.DUB sVOL r Setting on the Palmcorder: V/REW PLAY FF/W W 61 5 Set [REMOTE] on the [OTHER FUNCTIONS] Sub-Menu to the desired 2 STILL ADV PAUSE STILL ADV E ; D INDEX STOP INDEX K ∫ L Remote Controller Mode. 1 Setting on the Remote Controller: SELECT VAR. SEARCH STORE MENU OFF/ON P.B. ZOOM SET [VCR1]: Press the [D] Button and [∫] Button simultaneously. 1 [VCR2]: Press the [E] Button and [∫] Button simultaneously. 2 ≥When the battery in the Remote Controller is replaced, the Mode is P.B.DIGITAL ITEM automatically reset to [VCR1] Mode. 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92

13
1
3
2
1
ZOOM
INDEX
INDEX
SELECT
STORE
STOP
K
L
OSD
COUNTER
V
/REW
STILL ADV
OFF/ON
P.B.DIGITAL
DATE/
TIME
RESET
TITLE
T
W
s
VOL
r
¥
REC
MULTI/
P-IN-P
PHOTO
SHOT
START/
STOP
A.DUB
PLAY
PAUSE
FF/
W
STILL ADV
MENU
ITEM
SET
6
1
5
;
E
D
VAR.
SEARCH
P.B.
ZOOM
1
15˚
15˚
15˚
2
1
ª
Inserting the Button-type Battery
Before using the remote controller, insert the supplied button-type battery.
1
While pressing the Stopper
1
, pull out the Battery Holder.
2
Insert the button-type battery with the imprint (
i
) facing
upward.
3
Insert the Battery Holder into the Remote Controller.
When the button-type battery becomes weak, replace it with a new CR2025
battery. (A battery is normally expected to last about one year. However, it
depends on operation frequency.)
Be sure to match the poles properly when inserting the battery.
......................................................................................................................................................................
Warning
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the
equipment manufacturer. Discard used batteries according to
manufacturer’s instructions.
Risk of fire, explosion and burns. Do not recharge, disassemble, heat
above 212°F (100°C) or incinerate. Keep the Button-Type battery out of
the reach of children. Never put Button-Type battery in mouth. If
swallowed, call your doctor.
......................................................................................................................................................................
Replace battery with Panasonic PART NO. CR2025 only. Use of another
battery may present a risk of fire or explosion.
Caution: Battery may explode if mistreated.
Dispose of used battery promptly. Keep away from children.
Do not recharge, disassemble or dispose of in fire.
ª
Using the Remote Controller
1
Direct the Remote Controller at the Remote Control Sensor
on the Palmcorder and press the desired button.
Distance from the Palmcorder: Within approximately 15 feet (5 meters)
Angle: Within approximately 5
o
in the upward, and 15
o
in the downward
and horizontal directions from the central axis
The above operating ranges are for indoor use. Outdoors, or under strong
light, the equipment may not operate properly even within the above
ranges.
Within 3 feet (1 meter) range, you can also use the Remote Controller on
the side (the LCD Monitor side) of the Palmcorder.
Selecting Remote Controller Modes
When two Palmcorders are used simultaneously, they can be operated
individually by selecting different Remote Controller Modes.
If the Remote Controller Mode on the Palmcorder and Remote Controller do
not match, [REMOTE] is displayed.
Setting on the Palmcorder:
Set [REMOTE] on the [OTHER FUNCTIONS] Sub-Menu to the desired
Remote Controller Mode.
Setting on the Remote Controller:
[VCR1]: Press the [
D
] Button and [
]
Button simultaneously.
1
[VCR2]: Press the [
E
] Button and [
]
Button simultaneously.
2
When the battery in the Remote Controller is replaced, the Mode is
automatically reset to [VCR1] Mode.