Pfaff creative 7570 Owner's Manual - Page 217

Error messages in embroidery mode • Needle thread broken or empty If the needle thread breaks or runs out the machine stops after max. 6 stitches and elicits the message: Attention: Needle thread is broken or supply is empty ok? To resume embroidering at the position at which the thread breakage occurred, press number key 9 and press the toot pedal. The machine now skips back 6 stitches. You can repeat this procedure as often as you wish. Then thread the needle thread and and press the foot pedal. By pressing the ok key the machine finishes embroidering the pattern automatically. • Check the bobbin thread The bobbin thread supply display blinks when the bobbin thread is running low. The machine stops and this message appears in the display: Bobbin thread running low ok? You can continue sewing if you think that the bobbin thread is sufficient for the rest of the section, however the bobbin thread supply display continues to blink. The display remains lit until a full bobbin has been inserted and you continue to sew. • Sewing foot lifter The sewing toot lifter must be brought to embro idery position before beginning to embroider. If it is not, the machine will not sew when you press the foot pedal and the message appears: Bring sewing foot lifter to embroidering/darning position ok? • Lower feed dog If the feed dog is not lowered for embroidering, the machine does not embroider when the foot pedal is pressed and the message appea rs: Lower feed dog ok? The feed dog must be lowered in embroideri mode. I: I ii I I I29