Sanyo PLC-XC50A RS232C Extend - Page 14

PLC-XC50/55 Expand Serial Command Functional Specifications 6.9 Other Status Read Command Status read command CR_STATUS[CR] CR_SIGNAL[CR] CR_VMUTE[CR] CR_FREEZE[CR] CR_PTIMER[CR] CR_TEMPWARN[CR] CR_TEMP[CR] CR_TEMPFAIL[CR] Item Get setting status of Projector behavior Get Signal Status if there is a signal or not Get setting status of No Show Get setting status of Freeze Get the operating status of Presentation Timer Get if temperature is close to abnormal temperature Get current temperature status Get temperature when sensors approach abnormal temperature 7. Error Code Table Error Code ? 101 Contents -When the received data cannot be decoded -Parameter determination error (digit number error, including invalid value, etc.) The function is not available in the selected Mode 102 Selected value is out of range (Not reflected) 103 Command mismatched to Hardware (command for Optional function which is not installed) 201 When reached upper or lower limit of increasing or decreasing data 301 Command cannot be executed during capturing display. Resend the command after a while 302 Command cannot be executed during Auto PC adjust operation. Resend the command after a while 402 Command cannot be executed during PIN code operation. Resend the command after a while. Note) These error codes are applied to Expand Command, not to Basic Command 14/67