Sanyo PLC-XC50A RS232C Extend - Page 35

PLC-XC50/55 Expand Serial Command Functional Specifications 8.10.8 CF_LOGO Command Command "CF_LOGO_%1_%2"[CR] %1 "0000"-"9999 Set LOGO PIN CODE directly "OFF Disable Logo function "DFLT Display Default Logo "USER Display Captured Logo %2 "UP Switch Logo setting in forward direction (OFF -- DFLT -- User - OFF...) "DN Switch Logo setting in backward direction (OFF -- User -- DFLT - OFF...) Set / Cancel Logo The value set by this command is stored in EEPROM and its setting is effective even after ALL is OFF This command is available in normal Power ON status. %1--- Set LOGO PIN CODE Details - When LOGO LOCK is in operation PIN CODE is correct Command is valid (Acceptable) PIN CODE is incorrect Command is invalid (Error Code "102") PIN CODE is out of %1 range ------ Command is invalid (Error Code "? ") -When LOGO LOCK is not in operation PIN CODE is within %1 range ------ Command is valid PIN CODE is out of %1 range ------ Command is invalid (Error Code "? ") Note) Receiving correct LOGO PIN CODE while LOGO LOCK is in operation enables to change LOGO setting, but it does not release LOGO LOCK. (LOGO LOCK continues.) Projector returns Error Code "101" by receiving USER in %2 when capture has not operated. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 8.10.9 CF_CEIL Command Command "CF_CEIL_%1"[CR] %1 "ON Set Ceiling to ON "OFF Set Ceiling to OFF Details Set/Cancel Ceiling setting. The value set by this command is stored in EEPROM and its setting is effective even after ALL is OFF This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 35/67