Sanyo PLC-XC50A RS232C Extend - Page 18

PLC-XC50/55 Expand Serial Command Functional Specifications 8.4.8 CF_COLTEMP Command Command "CF_COLTEMP_%1"[CR] "000" ------ Xlow %1 "001" ------ Low "002" ------ Mid "003" ------ High Details Set Color Temperature. (Available only in the normal Power ON status) The value set by this command will not be saved to the projector. Therefore, when turning into Standby-mode or ALL is OFF, the value returns to original setting. (The value is held in Suspend mode.) This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 8.4.9 CF_PROGV Command Command "CF_PROGV_%1"[CR] "FILM" -------- Select Progressive Mode FILM "L1 Select Progressive Mode L1 "L2 Select Progressive Mode L2 %1 "OFF" --------- Cancel Progressive scan "UP Switch Progressive mode in forward direction OFF -- L1 -- L2 -- FILM -- OFF "DN Switch Progressive mode in backward direction OFF -- FILM -- L2 -- L1 -- OFF Details Set / cancel Progressive scan The value set by this command will not be saved to projector. Therefore, when turning into Standby-mode or ALL is OFF, the value returns to original setting. (The value is held in Suspend mode.) This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 8.4.10 CF_NZRED Command Command "CF_NZRED_%1"[CR] "OFF" ------- Cancel Noise Reduction "L1" --------- Noise Reduction for moving image "L2" --------- Noise Reduction for still image %1 "UP Switch Progressive mode in forward direction OFF -- L1 -- L2 -- OFF "DN Switch Progressive mode in backward direction OFF -- L2 -- L1 -- OFF Details Set / cancel Noise Reduction. The value set by this command will not be saved to projector. Therefore, when turning into Standby-mode or ALL is OFF, the value returns to original setting. (The value is held in Suspend mode.) This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 18/67