Sanyo PLC-XC50A RS232C Extend - Page 17

PLC-XC50/55 Expand Serial Command Functional Specifications 8.4.5 CF_SHARP Command Command "CF_SHARP_%1"[CR] "000~015 Directly select Sharpness setting value %1 "UP Current Sharpness setting value + 1 "DN Current Sharpness setting value - 1 Details Set Sharpness value of user control The value set by this command will not be saved to projector. Therefore, when turning into Standby-mode or ALL is OFF, the value returns to original setting. (The value is held in Suspend mode.) This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 8.4.6 CF_GAMMA Command Command "CF_GAMMA_%1"[CR] "000~015 Directly set Gamma setting value %1 "UP Current Gamma setting value + 1 "DN Current Gamma setting value - 1 Details Set Gamma value of user control The value set by this command will not be saved to projector. Therefore, when turning into Standby-mode or ALL is OFF, the value returns to original setting. (The value is held in Suspend mode.) This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 8.4.7 CF_WBAL - Command Command "CF_WBAL-%1_%2"[CR] Red %1 Green Blue "000~063 Directly select Color value specified by White Balance%1 %2 "UP Current Color value set by White Balance%1 + 1 "DN Current Color value set by White Balance%1 - 1 Details Set Color value set by White Balance%1 of user control The value set by this command will not be saved to projector. Therefore, when turning into Standby-mode or ALL is OFF, the value returns to original setting. (The value is held in Suspend mode.) This command is available in normal Power ON status. Acceptable "000"[CR] Response Unacceptable "Error Code"[CR] 17/67