Sony DSR 45A Operating Instructions - Page 48

Connections for Digital Non-linear Editing The unit can be connected to an editing controller via DV jacks to configure a digital non-linear editing system. The following figure shows a connection diagram for non-linear editing system in which this unit serves. For connection of the editing controller and its peripheral devices, refer to the instruction manual of the editing controller and that of the editing software you use. Edit functions are specified by the editing software. For details on the editing methods used, refer to the instruction manual of the editing software. DSR-45/45P MONITOR VIDEO MONITOR AUDIO 1 Video input Video monitor 1 Audio input Chapter 3 Using the Unit as a Player in an Editing System DV 2 Editing controller DV jack If the editing software used has the capability to output the time code as well as the video or audio signals from the digital non-linear editing controller to this unit, and you intend to record the time code, set DV IN TC on the TC/UB SET menu of this unit to EXTERNAL. For details on the TC/UB SET menu, see "TC/UB SET menu" on page 78 (GB). 1 Phono jack cable (not supplied) 2 i.LINK cable (DV cable) (not supplied) Note If the unit is connected to a device equipped with a 6pin DV jack, when you intend to disconnect or reconnect the DV cable, turn off the device and pull out the plug of its power cord from the AC outlet beforehand. If you connect or disconnect the DV cable while the device is connected to the AC outlet, highvoltage current (8 to 40 V) is output from the DV jack of the device to this unit, which may cause a malfunction. 48 (GB) Chapter 3 Using the Unit as a Player in an Editing System