Sony KLV-21SG2 Operating Instructions - Page 12
Connecting a VCR and Cable TV
View all Sony KLV-21SG2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Installing and Connecting the TV Connecting a VCR and Cable TV Use this hookup if: • You subscribe to a cable TV system that does not require a cable box. Disconnect all power sources before making any connections. 1 Connect the CATV cable to the VCR's IN jack. 2 Using the supplied 75-ohm coaxial cable, connect the VCR's OUT jack to the TV's VHF/UHF jack. 3 Using AUDIO and S VIDEO cables, connect the VCR's AUDIO and S VIDEO OUT jacks to the TV's AUDIO and S VIDEO IN jacks. Rear of TV 75-ohm coaxial cable (supplied) 75-ohm coaxial cable (supplied) S VIDEO VCR VIDEO (yellow) AUDIO-L (white) Cable S VIDEO cable (not supplied) AUDIO-R (red) AUDIO cable (not supplied) Note When you connect video equipment to both the VIDEO and the S VIDEO input jacks, make sure "Auto YC" in the (Setup) menu is set to "On" to view the S VIDEO input (see below). Tips • You can also use the VIDEO 2 IN jacks located on the left side of the TV to connect your VCR. • If your VCR is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S VIDEO cable. When connecting both VIDEO IN and S VIDEO IN Using the menu, you can select the jack from which the TV receives the input signal. You can set it for each video input (VIDEO 1 IN and VIDEO 2 IN) separately. The TV is factory set to receive S VIDEO input signals. 1 Press TV/VIDEO repeatedly until the desired video input appears. 2 Press MENU. 3 Press V/v to select (Setup), then press . 4 Press V/v to select "Auto YC," then press . 5 To watch the pictures input from the S VIDEO input jack: Press V/v to select "On," then press . To watch the pictures input from the VIDEO input jack: Press V/v to select "Off," then press . 12 6 Press MENU to exit the menu screen.