Sony SNC-RS44N User Guide - Page 35
Installation Tab, Initialize Tab, OK/Cancel, Video output mode, Reboot, Factory default
UPC - 027242254855
View all Sony SNC-RS44N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Administrating the Camera North: Change the direction of the camera and click Set. This will set that direction as north. Click Call to change the direction of the camera to the direction set as north. Area title Set the display name for the area the camera is facing. The maximum number of areas that you can register is 64. 1 Enter the string to display. 2 Put a check in the checkbox. 3 Move the camera to the specified lower left area and click Lower left. 4 Move the camera to the specified upper right area and click Upper right. 5 Click Set. OK/Cancel See "Buttons common to every menu" on page 29. Installation Tab You can perform settings related to installation. Display sample: Video output mode Configure or confirm the signal output settings from the analog image output terminal of the camera. SNC-RH124, SNC-RH164 You can change the signal setting for NTSC or PAL. Select either of NTSC + IP or PAL + IP. No analog image outputs when IP only is selected. SNC-RS46N/P, SNC-RS44N/P, SNC-RS86N/P, SNC-RS84N/P Displays either NTSC or PAL. Line lock (SNC-RS46N/P, SNC-RS44N/P, SNC-RS86N/P, SNC-RS84N/P only) Select either of Internal or External. Phase adjustment (SNC-RS46N/P, SNC-RS44N/ P, SNC-RS86N/P, SNC-RS84N/P only) Enter a value. (0 to 360) Note Phase adjustment is available when the Line lock setting is External. OK/Cancel See "Buttons common to every menu" on page 29. Initialize Tab Reboot Reboots the camera. Click Reboot, and the message "This Camera will be rebooted. Are you sure?" appears. Click OK to reboot the camera. It takes about two minutes to restart. Factory default Resets the camera to the factory settings. Restore network setting When this item is checked, only the current network settings will be retained after reset. Click Factory default, and the message "Setup data will be initialized. Are you sure?" appears. When you click OK, the network indicator on the camera starts to blink. After adjustments of the default settings have finished, the camera reboots automatically. Do not turn off the camera until the camera reboots. Tip The camera can also be reset to the factory settings by turning on the power of this unit while pressing the reset button on the camera. For details, see the supplied Installation Manual. Backup setting data Saves the setting data of the camera in a file. Click Save, and follow the instructions on the Web browser to specify the folder and save the setting data of 35 Configuring the System - System Menu