Sony SNC-RS44N User Guide - Page 84

Administrating the Camera 1 Use the following buttons to specify the active area(s) and inactive area(s). Adding an active area Clicking Adding an active area will add an active area window in the center of the screen. When you place the cursor on the area, the cursor changes to a crossed arrow, which you can drag to move the area. When you place the cursor on the vertex of the area, the cursor changes to n, which you can drag to move the vertex. Adding an inactive area Clicking Adding an inactive area will add an inactive area window in the center of the screen. When you place the cursor on the area, the cursor changes to a crossed arrow, which you can drag to move the area. When you place the cursor on the vertex of the area, the cursor changes to n, which you can drag to move the vertex. Deleting a region Clicking Deleting a region will delete the selected active area or inactive area. To select an area, click on the center or side of the area. Adding a vertex Clicking Adding a vertex will change the cursor to a button. In that state, when you click on a part of the side of the area, a vertex is added to that point. After the addition, the cursor will return to move mode. It is the same function as the button displayed in VMF settings. Deleting a vertex Clicking Deleting a vertex will change the cursor to a button. In that state, when you click on a part of the side of the area, the vertex added to that point is deleted. After the deletion, the cursor will return to move mode. It is the same function as the button displayed in VMF settings. Note The vertex can be moved in an outward direction but cannot be moved toward the inside of an area. Detection sensitivity Set the sensitivity of motion detection. A value from 1 to 100 can be specified. The values of the slide bar and spin button are synchronized. Clicking Return to the default changes the value to the default value. Detection response Set the response velocity of motion detection. A value from 1 to 5 can be specified. Clicking Return to the default changes the value to the default value. Detection size Specify the minimum detection size and maximum detection size of motion detection. To specify the detection size, you can either enter values or drag the vertexes of the area. The area size is measured in pixels. • When you place the cursor on the area, the cursor changes to a crossed arrow, which you can drag to move to the minimum detection size area and maximum detection size area. 84 Setting the Motion Detection/VMF Function - Motion detection Menu