Sony STRDG920 Operating Instructions - Page 114
Specifications, AUDIO POWER - reset
UPC - 027242729896
View all Sony STRDG920 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 114 highlights
Specifications AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION: (Models of area code U only) With 8 ohm loads, both channels driven, from 20 - 20,000 Hz; rated 100 watts per channel minimum RMS power, with no more than 0.09% total harmonic distortion from 250 milliwatts to rated output. Amplifier section Models of area code U, CA1) Minimum RMS Output Power (8 ohms, 20 Hz - 20 kHz, THD 0.09%) 100 W + 100 W Stereo Mode Output Power (8 ohms, 1 kHz, THD 0.7%) 110 W + 110 W Surround Mode Output Power2) (8 ohms, 1 kHz, THD 10%) 150 W per channel 1)Measured under the following conditions: Area code Power requirements U, CA 120 V AC, 60 Hz 2)Reference power output for front, center, surround and surround back speakers. Depending on the sound field settings and the source, there may be no sound output. Frequency response Analog 10 Hz - 100 kHz, ±3 dB (with sound field and equalizer bypassed) Input Analog Digital (Coaxial) Digital (Optical) Output (Analog) AUDIO OUT SUBWOOFER Equalizer Gain levels Sensitivity: 150 mV/ 50 kohms S/N3): 96 dB (A, 20 kHz LPF) Impedance: 75 ohms S/N: 100 dB (A, 20 kHz LPF) S/N: 100 dB (A, 20 kHz LPF) Voltage: 150 mV/1 kohms Voltage: 2 V/1 kohm ±10 dB, 1 dB step 3)INPUT SHORT (with sound field and equalizer bypassed). FM tuner section Tuning range 87.5 - 108.0 MHz Antenna (aerial) FM wire antenna (aerial) Antenna (aerial) terminals 75 ohms, unbalanced Intermediate frequency 10.7 MHz AM tuner section Tuning range Models of area code U, CA With 10-kHz tuning scale: 530 - 1,710 kHz4) With 9-kHz tuning scale: 531 - 1,710 kHz4) Antenna (aerial) Loop antenna (aerial) Intermediate frequency 450 kHz 4)You can change the AM tuning scale to 9 kHz or 10 kHz. After tuning in any AM station, turn off the receiver. While holding down TUNING MODE, press POWER. All preset stations will be erased when you change the tuning scale. To reset the scale to 10 kHz (or 9 kHz), repeat the procedure. 114US