Sony STRDG920 Operating Instructions - Page 94
Performing Auto Calibration, To operate on the receiver, To cancel Auto Calibration
UPC - 027242729896
View all Sony STRDG920 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
Performing Auto Calibration For details on the Auto Calibration, see "9: Calibrating the appropriate speaker settings automatically (Auto Calibration)" (page 39). Refer to "Before you perform Auto Calibration" (page 40) before performing the Auto Calibration. To operate on the receiver 1 Press GUI MODE repeatedly to select "GUI OFF". 2 Press AMP. Receiver operation is enabled. 3 Press MENU. 4 Press V/v repeatedly to select "", then press . 5 Press V/v repeatedly to select "A.CAL START", then press to start the measurement. Measurement starts in 5 seconds. A count down is displayed. Note While the time is counting down, stand away from the measurement area to avoid measurement error. 6 Measurement starts. The measurement process will take approximately 30 seconds. Wait until the measurement process completes. To cancel Auto Calibration The measurement will be canceled when you do the following: - Press ?/1, input buttons or MUTING. - Press SPEAKERS (OFF/A/B/A+B) on the receiver. - Change the volume level. - Connect the headphones. Tips • Operations other than turning the receiver on or off are deactivated during Auto Calibration. • The measurements may not be performed correctly or Auto Calibration cannot be performed when special speakers, such as dipole speakers are used. To confirm/save Auto Calibration when GUI function is turned off 1 Confirm the measurement result. When the measurement ends, a beep sounds and the measurement result appears on the display. Measurement Display result Explanation When the measurement process completes properly When the measurement process fails COMPLETE Proceed to step 2. E - xxx : xx See "Message list after Auto Calibration measurement" (page 43). 2 Press V/v repeatedly to select the item, then press . Item Explanation RETRY Performs the Auto Calibration again. SAVE EXIT Saves the measurement results and exits the setting process. WARN CHECK Displays a warning concerning the measurement results. See "Message list after Auto Calibration measurement" (page 43). PHASE INFO. Displays the phase of each speaker (in phase/out of phase). See "When you select "PHASE INFO."" (page 95). DIST. INFO. Displays the measurement result for speaker distance. 94US