TP-Link TL-WR1042ND User Guide - Page 22
TL-WR1042ND, Clone MAC Address, WAN MAC, Address
View all TP-Link TL-WR1042ND manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
TL-WR1042ND 300Mbps Wireless N Gigabit Router ¾ If the connection type detected is Dynamic IP, the next screen will appear as shown in Figure 3-8. z If you are visiting the Router from the main computer, please select Yes, and then click Clone MAC Address. Figure 3-8 Quick Setup - MAC Clone z If you are visiting the Router from another computer, rather than the main computer, please select No, and then enter the main computer's MAC in the field WAN MAC Address. Figure 3-9 Quick Setup - MAC Clone ) Note: 1. It's strongly recommended that you visit and configure the Router from the main computer. 2. To find the main computer's MAC, please go to Start > Run on your main computer, type in cmd and press Enter. At the command prompt, enter ipconfig/all and press Enter. The MAC will be displayed under Physical Address.(shown in the following figure) -13-