TP-Link TL-WR1042ND User Guide - Page 30
Network, 4.5.1 WAN, TL-WR1042ND, Clone, Network, Dynamic IP
View all TP-Link TL-WR1042ND manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
TL-WR1042ND 300Mbps Wireless N Gigabit Router ) Note: 1) The WPS LED on the Router will light green for five minutes if the device has been successfully added to the network. 2) The WPS function cannot be configured if the Wireless Function of the Router is disabled. Please make sure the Wireless Function is enabled before configuring the WPS. 4.5 Network Figure 4-5 the Network menu There are three submenus under the Network menu (shown in Figure 4-5): WAN, LAN and MAC Clone. Click any of them, and you will be able to configure the corresponding function. 4.5.1 WAN Choose menu "Network→WAN", and then you can configure the IP parameters of the WAN on the screen below. 1. If your ISP provides the DHCP service, please choose Dynamic IP type, and the Router will automatically get IP parameters from your ISP. You can see the page as follows (Figure 4-6): Figure 4-6 WAN - Dynamic IP -21-