Yamaha 401 Owner's Manual - Page 211

6 Secure A. 1 Adjust the position of A so that the left and right ends of A will project beyond D and E equally when seen from the front. 2 Secure A by tightening the short screws (6 ✕ 16mm) from the front. 1 Center A to produce equal A clearance on the left and right sides. WARNING An improper voltage setting can cause serious damage to the Clavinova or result in improper operation. 9 Set the adjuster. Rotate the adjuster until it comes in firm contact with the floor surface. 2 Use 6x16 mm short screws to secure A from the front. 7 Connect the pedal cord. 1 Insert the pedal cord plug to the pedal connector from the rear. 3 Use a vinyl tie to take up any slack in the pedal cord. 2 Attach the cord holders to the rear panel as shown, then clip the cord into the holders. 8 Set the voltage selector and connect the power cord. ■ After completing the assembly, please check the following. • Are there any parts left over? → Review the assembly procedure and correct any errors. • Is the Clavinova clear of doors and other movable fixtures? → Move the Clavinova to an appropriate location. • Does the Clavinova make a rattling noise when you shake it? → Tighten all screws. • Does the pedal box rattle or give way when you step on the pedals? → Turn the adjuster so that it is set firmly against the floor. • Are the pedal and power cords inserted securely into the sockets? → Check the connection. • If the main unit creaks or is otherwise unsteady when you play on the keyboard, refer to the assembly diagrams and retighten all screws. When moving the instrument after assembly, always hold the bottom of the main unit. CAUTION Do not hold the key cover or top portion. Improper handling can result in damage to the instrument or personal injury. Top portion 127 110 240 Voltage Selector Before connecting the AC power cord, check the setting of the voltage selector which is provided in some areas. To set the selector for 110V, 127V, 220V or 240V main voltages, use a "minus" screwdriver to rotate the selector dial so that the correct voltage for your region appears next to the pointer on the panel. The voltage selector is set at 240V when the unit is initially shipped. After the proper voltage has been selected, connect the AC power cord to the AC INLET and an AC wall outlet. A plug adaptor may be also provided in some areas to match the pin configuration of the AC wall outlets in your area. Key cover Do not hold here. Hold here. Do not hold here. CVP-405/403/401 Owner's Manual 211 Appendix 220