Yamaha EZ-220 Owner's Manual - Page 44
Appendix, Troubleshooting - headphones
View all Yamaha EZ-220 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Appendix Troubleshooting Problem When the instrument is turned on or off, a popping sound is temporarily produced. The power is automatically turned off. When using a mobile phone, noise is produced. There is no sound even when the keyboard is played or when a Song or Style is being played back. Playing keys in the right-hand area of the keyboard does not produce any sound. • The volume is too soft. • The sound quality is poor. • The rhythm stops unexpectedly or will not play. • All settings have been restored to their defaults. • The Song, etc. does not play correctly. The Style or Song does not play back when the [START/STOP] button is pressed. The Style does not sound properly No rhythm accompaniment plays when the [START/STOP] button is pressed after selecting one of the Style numbers 093-100 (Pianist). Not all of the voices seem to sound, or the sound seems to be cut off. The footswitch (for sustain) seems to produce the opposite effect. For example, pressing the footswitch cuts off the sound and releasing it sustains the sounds. The ACMP ON indicator does not appear when the [ACMP ON/OFF] button is pressed. The part indications, such as Right, Left and Both Hands, do not appear-even when pressing the [R] or [L] buttons for the Lesson. The sound of the voice changes from note to note. A faint, high-pitched mosquito-like sound may be heard from the internal speaker. When a Style is in use, the Page Turner function cannot be used even if the button is pressed. Possible Cause and Solution This is normal and indicates that the instrument is receiving electrical power. This is normal and due to the Auto Power Off function. If necessary, set the parameter of the Auto Power Off function (page 11). Using a mobile phone in close proximity to the instrument may produce interference. To prevent this, turn off the mobile phone or use it further away from the instrument. Check that nothing is connected to the PHONES/OUTPUT jack on the rear panel. When a set of headphones is plugged into this jack, no sound is output. Check the Local Control on/off. (See page 41.) When using the Chord Dictionary function (page 38), the keys in the righthand area are used only for entering the chord root and type. The batteries are low or dead. Replace all six batteries with completely new ones or already-recharged ones, or use the optional AC adaptor. Is External Clock set to ON? Make sure External Clock is set to OFF; refer to "External Clock Settings" on page 41. Make sure that the Style Volume (page 39) is set to an appropriate level. Is the Split Point set at an appropriate key for the cords you are playing? Set the Split Point at an appropriate key (page 39). Is the "ACMP ON" indicator showing in the display? If it is not, press the [ACMP ON/OFF] button so that it does show. This is not a malfunction. Style numbers 093-100 (Pianist) have no rhythm parts, so no rhythm will play. The other parts will begin playing when you play a chord in the accompaniment range of the keyboard if Auto Accompaniment is turned on. The instrument is polyphonic up to a maximum of 32 notes. If a style or Song is playing back at the same time, some notes/sounds may be omitted (or "stolen") from the accompaniment or Song. The polarity of the footswitch is reversed. Make sure that the footswitch plug is properly connected to the SUSTAIN jack before turning on the power. Always press the [STYLE] button first when you are going to use any stylerelated function. Make sure that you are not pressing the [R] or [L] buttons while the Song is playing. If you press one of the part buttons while playing the Song and before starting the Lesson, these buttons serve to mute the corresponding Song parts. Stop the Song first, then select the desired part and start the Lesson. The AWM tone generation method uses multiple recordings (samples) of an instrument across the range of the keyboard; thus, the actual sound of the voice may be slightly different from note to note. This is normal. Since the trigger for the Page Turn function uses audio signals (around 18kHz) output from the instrument speakers which are received by the iPad microphone, those audio signals may be heard. When you are not using the Page Turner function, it is a good idea to turn this function off. This is normal. The Page Turner function can be used when the Song or Lesson is in use. 44 EZ-220 Owner's Manual