ZyXEL P-792H v2 User Guide - Page 208

Chapter 15 Quality of Service (QoS) Table 62 Advanced > QoS > General LABEL DESCRIPTION Traffic priority will be automatically assigned by These fields are ignored if traffic matches a class you configured in the Class Setup screen. If you select ON and traffic does not match a class configured in the Class Setup screen, the P-792H v2 assigns priority to unmatched traffic based on the IEEE 802.1p priority level, IP precedence and/or packet length. See Section 15.6.4 on page 216 for more information. Apply Cancel If you select OFF, traffic which does not match a class is mapped to queue two. Click this to save your changes. Click this to restore your previously saved settings. 15.4 The Class Setup Screen Use this screen to add, edit or delete classifiers. A classifier groups traffic into data flows according to specific criteria such as the source address, destination address, source port number, destination port number or incoming interface. For example, you can configure a classifier to select traffic from the same protocol port (such as Telnet) to form a flow. Click Advanced > QoS > Class Setup to open the following screen. Figure 98 Advanced > QoS > Class Setup 208 The following table describes the labels in this screen. Table 63 Advanced > QoS > Class Setup LABEL DESCRIPTION Create a new Class Click Add to create a new classifier. No This is the number of each classifier. The ordering of the classifiers is important as the classifiers are applied in turn. Active Select the check box to enable this classifier. Name This is the name of the classifier. P-792H v2 User's Guide