ZyXEL P-792H v2 User Guide - Page 273
FTP Command Configuration Backup Example, Configuration Backup Using GUI-based FTP Clients, Backup
View all ZyXEL P-792H v2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 273 highlights
Chapter 21 Tools FTP Command Configuration Backup Example This figure gives an example of using FTP commands from the DOS command prompt to save your device's configuration onto your computer. Figure 118 FTP Session Example 331 Enter PASS command Password: 230 Logged in ftp> bin 200 Type I OK ftp> get rom-0 zyxel.rom 200 Port command okay 150 Opening data connection for STOR ras 226 File received OK ftp: 16384 bytes sent in 1.10Seconds 297.89Kbytes/sec. ftp> quit Configuration Backup Using GUI-based FTP Clients The following table describes some of the commands that you may see in GUIbased FTP clients. Table 99 General Commands for GUI-based FTP Clients COMMAND DESCRIPTION Host Address Enter the address of the host server. Login Type Anonymous. This is when a user I.D. and password is automatically supplied to the server for anonymous access. Anonymous logins will work only if your ISP or service administrator has enabled this option. Normal. Transfer Type Initial Remote Directory Initial Local Directory The server requires a unique User ID and Password to login. Transfer files in either ASCII (plain text format) or in binary mode. Specify the default remote directory (path). Specify the default local directory (path). Backup Configuration Using TFTP The P-792H v2 supports the up/downloading of the firmware and the configuration file using TFTP (Trivial File Transfer Protocol) over LAN. Although TFTP should work over WAN as well, it is not recommended. To use TFTP, your computer must have both telnet and TFTP clients. To backup the configuration file, follow the procedure shown next. P-792H v2 User's Guide 273