ZyXEL P-792H v2 User Guide - Page 64
Network > WAN > Internet Access Setup continued
View all ZyXEL P-792H v2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Chapter 6 WAN Setup Table 12 Network > WAN > Internet Access Setup (continued) LABEL DESCRIPTION Tag VLAN ID for Select this option to add the VLAN tag (specified below) to the egree packets outgoing traffic through this connection. Enter 802.1P Priority This is available only when you select PTM in the Transfer Mode field. IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame that contains bits to define class of service. Enter 802.1Q VLAN ID Line IP Address Type the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection. The greater the number, the higher the priority level. Type the VLAN ID number (from 1 to 4094) for traffic through this connection. Select the DSL line you want the P-792H v2 to use as a default for outgoing traffic (remote node 1). This option is available if you select Routing in the Mode field. A static IP address is a fixed IP that your ISP gives you. A dynamic IP address is not fixed; the ISP assigns you a different one each time you connect to the Internet. Subnet Mask Select Obtain an IP Address Automatically if you have a dynamic IP address; otherwise select Static IP Address and type your ISP assigned IP address in the IP Address field below. This option is available if you select ENET ENCAP in the Encapsulation field. Gateway IP address Enter a subnet mask in dotted decimal notation. This option is available if you select ENET ENCAP in the Encapsulation field. Specify a gateway IP address (supplied by your ISP). DNS Server First DNS Server Second DNS Server Third DNS Server Select Obtained From ISP if your ISP dynamically assigns DNS server information (and the P-792H v2's WAN IP address) and you select Obtain an IP Address Automatically. Select User-Defined if you have the IP address of a DNS server. Enter the DNS server's IP address in the field to the right. If you chose User-Defined, but leave the IP address set to 0.0.0.0, UserDefined changes to None after you click Apply. If you set a second choice to User-Defined, and enter the same IP address, the second User-Defined changes to None after you click Apply. Select None if you do not want to configure DNS servers. You must have another DNS server on your LAN, or else the computers must have their DNS server addresses manually configured. If you do not configure a DNS server, you must know the IP address of a computer in order to access it. Connection (PPPoA and PPPoE encapsulation only) Nailed-Up Connection Select Nailed-Up Connection when you want your connection up all the time. The P-792H v2 will try to bring up the connection automatically if it is disconnected. 64 P-792H v2 User's Guide