ZyXEL P-792H v2 User Guide - Page 308
Remote Node Profile
View all ZyXEL P-792H v2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 308 highlights
Chapter 28 Remote Node Setup 28.3 Remote Node Profile The following explains how to configure remote nodes 1-7. Figure 144 Menu 11.1: Remote Node Profile (nodes 1-7) Menu 11.1 - Remote Node Profile Rem Node Name= MyISP Active= Yes Route= IP Bridge= No Encapsulation= PPPoE Multiplexing= LLC-based Service Name= Incoming: Rem Login= Rem Password= ******** Outgoing: My Login= My Password= ******** Authen= CHAP/PAP Edit IP/Bridge= No Edit ATM/PTM Options= No Edit Advance Options= No Telco Option: Allocated Budget(min)= 0 Period(hr)= 0 Schedule Sets= Nailed-Up Connection= No Session Options: Edit Filter Sets= No Idle Timeout(sec)= 0 The following table describes the labels in this menu. Table 115 Menu 11.1: Remote Node Profile (nodes 1-7) FIELD DESCRIPTION Rem Node Name Enter the name of the ISP. Active Select whether or not you want to use this Internet connection. Encapsulation Select the type of encapsulation your ISP uses: PPPoE, RFC 1483, PPPoA, or ENET ENCAP. Multiplexing Select the method of multiplexing used by your ISP from the dropdown list. Choices are VC-based or LLC-based. Service Name (PPPoE only) Enter the service name provided by your ISP. Leave this field blank if your ISP did not provide one. Incoming This section is only enabled for PPPoA or PPPoE connections. Rem Login Type the login name that this remote node will use to call your P792H v2. The login name and the Rem Password will be used to authenticate this node. Rem Password Type the password used when this remote node calls your P-792H v2. Outgoing This section is only enabled for PPPoA or PPPoE connections. My Login Enter the user name provided by your ISP. My Password Enter the password provided by your ISP. Retype to Confirm Enter the password again. 308 P-792H v2 User's Guide