ZyXEL P-792H v2 User Guide - Page 211
Table 64
View all ZyXEL P-792H v2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 211 highlights
Chapter 15 Quality of Service (QoS) See Appendix F on page 455 for a list of commonly-used services. The following table describes the labels in this screen. Table 64 Advanced > QoS > Class Setup: Edit LABEL DESCRIPTION Class Configuration Active Select the check box to enable this classifier. Name The text may consist of up to 20 letters, numerals and any printable character found on a typical English language keyboard. Interface Select from which interface traffic of this class should come. Priority Select a priority level (between 0 and 7) or select Auto to have the P792H v2 map the matched traffic to a queue according to the internal QoS mapping table. See Section 15.6.4 on page 216 for more information. Routing Policy "0" is the lowest priority level and "7" is the highest. Select the next hop to which traffic of this class should be forwarded. Select By Routing Table to have the P-792H v2 use the routing table to find a next hop and forward the matched packets automatically. Select To WAN Index to route the matched packets through the specified PVC. This option is available only when the WAN type is ADSL. Select To Gateway Address to route the matched packets to the router or switch you specified in the Gateway Address field. WAN Index Select a PVC index number. Gateway Address Enter the IP address of the gateway, which should be a router or switch on the same segment as the P-792H v2's interface(s), that can forward the packet to the destination. Order This shows the ordering number of this classifier. Select an existing number for where you want to put this classifier and click Apply to move the classifier to the number you selected. For example, if you select 2, the classifier you are moving becomes number 2 and the previous classifier 2 gets pushed down one. Tag Configuration DSCP Value Select Same to keep the DSCP fields in the packets. Select Auto to map the DSCP value to 802.1 priority level automatically. Select Mark to set the DSCP field with the value you configure in the field provided. P-792H v2 User's Guide 211