2006 Ducati Multistrada 1000 DS Owners Manual - Page 126
2006 Ducati Multistrada 1000 DS Manual
Page 126 highlights
Procedure to disable immobilizer engine block through throttle twistgrip 1) Turn the ignition key to ON and fully open the throttle. Keep it open. The EOBD warning light (5, fig. 6) turns off after 8 seconds. 2) Release the throttle as soon as the EOBD warning light turns off. 3) The EOBD warning light will flash. Now enter the electronic release code shown on the CODE CARD given to the customer at the time of consignment of the motorcycle by the dealer. 4) Count a number of flashes of the EOBD light equivalent to the first number of the secret code. Open full throttle and keep the position for 2 seconds, then release. In this way the input of one figure is acknowledged, the EOBD warning light comes on and stays on for 4 seconds. Repeat the operation until you have entered the final digit. If you fail to perform any operation with the throttle the EOBD light will flash 20 times and then illuminate steadily to inform you that the procedure must be repeated from step 1. 5) When you release the throttle grip, if the code has been entered correctly the following two cases may occur: A) the EOBD light starts flashing to indicate that engine is enabled. The light switches off after 4 seconds, or if engine speed exceeds the threshold value of 1000 rpm. B) the IMMO warning light (3, fig. 5) flashes until engine speed rises above 1000 rpm, or until the engine is re-started. 6) Should the code NOT be entered correctly both the EOBD and IMMO lights stay on and it is possible to repeat the procedure starting again from point 2 for as many times as necessary. Notes If you release the twistgrip too soon, the warning light comes on again. Return the ignition key to OFF and repeat the procedure from step 1. E 27