1996 Ford Explorer Owner's Manual - Page 200
1996 Ford Explorer Manual
Page 200 highlights
Calibration adjustment: 1. Find an open area that is free from steel structures and high voltage lines. An open parking lot is a good example. 2. Press and hold the "MODE" button until the "CAL" indicator appears in the display (approximately 8 seconds). NOTE: You cannot perform calibration unless the display reads "CAL." 3. Release the "MODE" button. 4. Once the "CAL" indicator has appeared, drive the vehicle slowly (less than 3 mph / 5 km/h) in 360˚ circles until the "CAL" indicator turns off. This will happen within 2 to 3 complete circles. Map lamps The map lamps are located in the overhead console. The driver and passenger side each has its own switch. Map lamps (If equipped) 200
200
Calibration adjustment:
1.
Find an open area that is free from steel structures and high
voltage lines. An open parking lot is a good example.
2.
Press and hold the “MODE” button until the “CAL”
indicator appears in the display (approximately 8 seconds).
NOTE:
You cannot perform calibration unless the display
reads “CAL.”
3.
Release the “MODE” button.
4.
Once the “CAL” indicator has appeared, drive the vehicle
slowly (less than 3 mph / 5 km/h) in 360˚ circles until the
“CAL” indicator turns off. This will happen within 2 to 3
complete circles.
Map lamps
The map lamps are located in the overhead console. The driver
and passenger side each has its own switch.
Map lamps (If equipped)