1996 Ford Explorer Owner's Manual - Page 74

For a warm engine: s Do not hold the key in the START position for more than five (5) seconds at a time. If the engine does not start within five (5) seconds on the first try, turn the key to the OFF position. Wait a few seconds after the starter stops, then try again. Whenever you start your vehicle, release the key as soon as the engine starts. Excessive cranking could damage the starter. After starting, allow the engine to idle for a few seconds before driving away. If the engine does not start after two attempts: 1. Turn the ignition key to the OFF position. 2. Press the accelerator all the way to the floor and hold it. 3. Turn the ignition key to the START position. 4. Release the ignition key when the engine starts. 5. Release the accelerator gradually as the engine speeds up. Then drive away in the normal manner. If the engine still does not start, the fuel pump shut-off switch may have been triggered. For directions on how to reset the switch see Fuel Pump Shut-Off Switch later in this chapter. A computer system controls the engine's idle speed. When you start your vehicle, the engine's idle speed normally runs high. These faster engine speeds will make your vehicle coast slightly faster than its normal idle speed. It should, however, slow down after a short time. If it does not, have the idle speed checked. If the engine idle speed does not slow down automatically, do not allow your vehicle to idle for more than 10 minutes. Have the vehicle checked. 72