2015 Kawasaki KX250F Owners Manual - Page 69

68 MAINTENANCE AND ADJUSTMENT removing the throttle body assy, cover the • After throttle body assy holder and air cleaner duct with WARNING Operation with improperly adjusted, incorrectly routed, or damaged cables could result in an unsafe riding condition. Be sure the control cables are adjusted and routed correctly, and are free from damage. the lower ends of the throttle cables. • Lubricate Install the tip of accelerator cable lower end to the • throttle pulley. the accelerator cable so that the position the • Install claw on the washer. the tip of decelerator cable lower end to the • Install throttle pulley. holding the decelerator cable bolt, tighten • While the cable bolt locknut. Tightening Torque Throttle Cable Bolts: 3.0 N·m (0.31 kgf·m, 27 in·lb) Throttle Pulley Cover Bolts: 3.4 N·m (0.35 kgf·m, 30 in·lb) j • • • a clean cloth to protect them from dirt. Clean the throttle body assy. Check the throttle bore at the throttle valve for carbon deposits by opening the throttle valve. If any carbon accumulates, wipe the carbon off the throttle bore and the throttle valve, using a lint-free cloth penetrated with a high flash-point solvent. A. Throttle Bore NOTICE If dirt gets through into the engine, excessive engine wear and possibly engine damage will occur.