2010 Mercedes S-Class Owner's Manual - Page 108

106 X X COMAND navigation system (entering a destination) Select Navi. Check the check box for menu item City (3D). X Setting route type You can set the following route types: Control systems RFast Route: COMAND calculates a route with minimized driving time. Route: COMAND calculates a route with minimized driving time and takes into account traffic messages received along the route. Thus, the navigation system can dynamically recalculate the route. Roads that are blocked will be avoided whenever possible. For information on traffic messages see (Y page 138). Route: COMAND calculates a route with minimized route length. RDynamic RShort X Select Navi Q Mode. The list of available rote types appears. The dot # indicates the currently selected setting. X Select route type: Fast Route, Dynamic Route or Short Route. X Exit menu: Slide XVY. Select Navi Q Mode. The mode list appears. X Switching mode on or off: Select desired modes. Depending on the previous status, the mode is switched on or off. A checkmark indicates that the mode is switched on. It is possible to switch on more than one mode. X Exiting menu: Slide XVY or press back button % in the center console (Y page 87). COMAND will verify whether it can incorporate the modes if you select them with route guidance active. If possible, COMAND calculates a new route considering the selected options. If the route cannot be recalculated with the selected options, a message appears and an announcement is made. COMAND calculates a new route. Only options that are possible will be considered. Displaying highway information When this function is enabled, highway information ahead will display automatically (Y page 137). i If you change the route type setting during active route guidance, COMAND calculates a new route. If you change the setting when route guidance is inactive, COMAND uses the new setting for the next route guidance. Setting route mode With this function you can select the following options for route calculation: RMinimize RMinimize RMinimize RMinimize RMinimize Audio fadeout X Select Navi Q Audio Fadeout. When the check box is checked U the volume of the current audio source fades during a navigation announcement. COMAND navigation system (entering a destination) Introduction G Warning! For safety reasons, only enter a new destination when the vehicle is stationary. Highways Toll Roads Tunnels Ferries Motorail Trains