2010 Mercedes S-Class Owner's Manual - Page 125

COMAND navigation system (entering a destination) RRestaurant ROther X 123 X Select Navi Q Destination Q Stopover. X Entering: Select Other. You can select between the following menu items: RAddress RFrom RFrom RFrom X Entering predefined destinations X Entry Select Navi Q Destination Q Stopover. If a stopover has already been entered, you can change it. Changing: Select Change Stopover. You can now select a category. X Selecting a category: Select category, e.g. Gas station. COMAND first looks for destinations along the vehicle's route and within the immediate vicinity of the vehicle. If there are no destinations available there, COMAND searches for destinations in an area around the vehicle position. If COMAND does not find any destinations, you will see a message to this effect. X Select OK. You can now select a different category. If COMAND finds destinations, you will see a list of the destinations and details of how far away they are in the right-hand side of the display. The information about how far away the destinations are can take a few seconds to be displayed. The left-hand part of the display shows the destinations on the map. The destination marked in the list is highlighted in the map. Memory Last Destinations POIs Select a menu item. Subsequent destination entries may differ, depending on your selection: RAddress X Entry selection: Enter a destination by address (Y page 107). RFrom Memory selection: X Enter a destination from the destination memory (Y page 120). X RFrom Last Destinations selection: Enter a destination from the list of last destinations (Y page 122). POIs selection: Enter a point of interest (POI) (Y page 124). RFrom X X Starting route calculation: After entering a destination, select Start (Y page 120). Changing a stopover If a stopover has already been entered, you can change it. Z Control systems With the option Other you can enter stopover destinations from the destination memory, last selected destinations, POIs, or via the address (Y page 123). You can enter stopover destinations on the route or in the vicinity of the route. You can use the stopover function to influence the route guidance calculation to the main destination. When you have reached your stopover, COMAND automatically calculates the route to the main destination. Selecting a destination: Select the desired destination from list. The address of the destination appears. X Starting route calculation: Select Start, see also (Y page 120). Entering another destination as a stopover