2010 Mercedes S-Class Owner's Manual - Page 377
2010 Mercedes S-Class Manual
Page 377 highlights
Panorama roof with power tilt/sliding panel in direction of arrow = until the tilt/sliding sunroof is fully closed. The tilt/sliding sunroof closes with greater force. If the tilt/sliding sunroof is blocked again and opens slightly: X 375 Panorama roof with power tilt/ sliding panel Extending and retracting the roller sunblinds The roller sunblinds only operate with the tilt/ sliding panel closed. The front and rear roller sunblind can be operated individually. X Switch on the ignition. Operating front roller sunblind G Warning! When extending the front roller sunblind, make sure no one is in danger of being injured by the extending procedure. The front roller sunblind is equipped with the express operation and automatic reversal function. If the movement of the front roller sunblind is blocked during the extending procedure, the front roller sunblind will stop and retract slightly. The extending of the front roller sunblind can be immediately halted by releasing the roof panel switch or, if the roof panel switch was moved past the resistance point and released, by moving the roof panel switch in any direction. G Warning! Pulling and holding the sunroof switch to close the tilt/sliding sunroof immediately after it had been blocked two times will cause the tilt/sliding sunroof to close without any reversal function for as long as you hold the sunroof switch. Synchronizing The tilt/sliding sunroof must be synchronized after a malfunction or if it does not open smoothly. ! If the tilt/sliding sunroof cannot be closed or synchronized, contact an authorized Mercedes-Benz Center or call Roadside Assistance. X X Switch on the ignition. Press and hold the sunroof switch in direction of arrow : (Y page 374) until the tilt/sliding sunroof is fully raised at the rear. X Keep holding the sunroof switch in direction of arrow : for approximately 1 second. X Check the express operation feature (Y page 374). If the tilt/sliding sunroof opens and closes completely, the roof is synchronized. Otherwise repeat the above steps. Roof panel switch : Retracting ; Retracting = Extending X Retracting/Extending: Move the roof panel switch to the resistance point in the Z Controls in detail Immediately after the tilt/sliding sunroof was blocked and has opened, pull and hold the sunroof switch in direction of arrow = until the tilt/sliding sunroof is fully closed. The tilt/sliding sunroof closes without automatic reversal function.