2010 Mercedes S-Class Owner's Manual - Page 400
2010 Mercedes S-Class Manual
Page 400 highlights
398 Useful features Reprogramming a single signal transmitter button To program a device using a signal transmitter button previously trained, follow these steps: X Switch on the ignition. X Press and hold the desired signal transmitter button (;, = or ?). Do not release the button. Indicator lamp : will begin to flash after 20 seconds. X Without releasing the signal transmitter button, proceed with programming starting with step 3. Programming tips If you are having difficulty programming the integrated remote control, here are some helpful tips: RCheck the frequency of hand-held remote control A (typically located on the reverse side of the remote). The integrated remote control is compatible with radio-frequency devices operating between 280-390 MHz. a new battery in hand-held remote control A. This will increase the likelihood of the hand-held remote control sending a stronger and more accurate signal to the integrated remote control. performing step 3, hold hand-held remote control A at different lengths and angles from the signal transmitter button (;, = or ?) you are programming. Attempt varying angles at the distance of 2 to 12 inches (5 to 30 cm) away or the same angle at varying distances. another hand-held remote control is available for the same device, try the programming steps again using that other hand-held remote control. Make sure new batteries are in the hand-held remote control before beginning the procedure. the antenna wire from the garage door opener assembly. This may help improve transmitting and/or receiving signals. Controls in detail RPut Operation of integrated remote control X X RWhile Switch on the ignition. Select and press the appropriate integrated signal transmitter button (;, = or ?) to activate the remote controlled device. The integrated remote control transmitter continues to send the signal as long as the button is pressed - up to 20 seconds. RIf Erasing the integrated remote control memory i If you sell your vehicle, erase the codes of all three channels. X X RStraighten Switch on the ignition. Simultaneously press and hold outer signal transmitter buttons ; and ?, for approximately 20 seconds, until indicator lamp : flashes rapidly. Do not hold for longer than 30 seconds. The codes of all three channels are erased. i Certain types of garage door openers are incompatible with the integrated remote control. If you should experience further difficulties with programming the integrated remote control, contact an authorized Mercedes-Benz Center, or call the Mercedes-Benz Customer Assistance Center (USA only) at 1-800-FOR-MERCedes (1-800-367-6372), or the HomeLink® Hotline (USA only) at 1-800-355-3515, or the Customer Service (Canada only) at 1-800-387-0100.