Adaptec LSM-FC2002 Installation Guide - Page 53
RAID Controller Configurations, Setting the Enclosure ID
UPC - 760884145067
View all Adaptec LSM-FC2002 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
53 RAID Controller Configurations This section describes how to cable the two standard RAID controller configurations: Single RAID Controller and Dual RAID Controller (dual active). The procedure for daisy chaining these standard configurations to expansions enclosures is also described. This section also describes how to set the enclosure ID. Setting the Enclosure ID Each of the fourteen disk drive slots of the SANbloc Series has a unique identifier assigned to it. This identifier is assigned using a combination of the Slot number and the enclosure ID. The enclosure ID is set, using the enclosure ID switch, located on the rear of the SANbloc (see Figure 4-4). Note: The enclosure ID must be set prior to powering on the enclosure. Note: Each enclosure must have a separate ID when daisy chained together. RAID Controller Configurations