Adaptec LSM-FC2002 Installation Guide - Page 81
Installing and Removing a Power Supply, Installing a Power Supply, Supply, Removing a Power
UPC - 760884145067
View all Adaptec LSM-FC2002 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
81 Installing and Removing a Power Supply The power supplies are located in the rear of the enclosure. Follow these procedures to install and remove the power supplies. Installing a Power Supply 1 Select the power supply slot into which the power supply is to be inserted and remove the carrier blank if there is one installed. 2 Orient the power supply, such that the LEDs are on the top (on the right hand side for rack mount systems). 3 Gently slide the power supply into the empty power supply slot. 4 Secure in place using the two fixing screws (torque setting 0.3Nm). 5 Install the power cables. Removing a Power Supply 1 Turn off the power supply, and remove the power cable. 2 Loosen the two fixing screws. 3 Using the power supply handle, gently slide it out of the enclosure. CAUTION: Immediately replace the power supply carrier or install a power supply carrier blank to maintain correct airflow. Figure 6-3 Power Supply I 0 AC Inlet Handle On/Off Switch Installing and Removing a Power Supply