Adaptec LSM-FC2002 Installation Guide - Page 83
Installing and Removing an I/O Module/RAID Controller, Installing an I/O, Module/RAID, Controller
UPC - 760884145067
View all Adaptec LSM-FC2002 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
83 Installing and Removing an I/O Module/RAID Controller Note: In the following section, "I/O Module" is taken to include the RAID Controller in addition to the I/O Module. Installing an I/O Module/RAID Controller Removing an I/O Module/RAID Controller The I/O module is located in the rear of the enclosure. Follow these procedures to install and remove the I/O module. 1 Remove the I/O module blank if there is one installed. 2 Gently insert the I/O module into the slot. 3 Secure in place using the two fixing screws (torque setting 0.3Nm). 4 Connect the cables as described in Chapter 3. 1 Remove all cables. 2 Loosen the two fixing screws. 3 Using the module handle, gently slide the I/O Module out of the slot. CAUTION: Immediately replace the carrier or install an I/O module blank to maintain correct airflow. Installing and Removing an I/O Module/RAID Controller