Brother International BES-1260BC Instruction Manual - English - Page 29
Adjust the height of the F table guide U, on the leg.
View all Brother International BES-1260BC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Chapter 2 Preparation of Embroidery Machine i o Pin t y u q Lower by 1 mm e 4. Mount four thumb bolts i each on the rear of F table R t, M (2 pcs.) y, and L u. 5. Mount five thumb bolts on the steel pipe below the front leg. 6. Insert the pins attached to the rear of the F table R t, M (2 pcs.) y, and L u into the cover o on the leg. Adjust the height of the F table guide U q and the F table support F e so that the table top surface will become 1 mm lower than the bed top surface. After adjustment is finished, tighten each bolt securely. 34 BES-960BC • BES-1260BC
Chapter 2
Preparation of Embroidery Machine
BES-960BC
•
BES-1260BC
34
q
e
Lower by 1 mm
Pin
i
o
u
y
t
4.
Mount four thumb bolts
i
each on the rear of F table R
t
, M (2 pcs.)
y
, and L
u
.
5.
Mount five thumb bolts on the steel pipe below the front leg.
6.
Insert the pins attached to the rear of the F table R
t
, M (2 pcs.)
y
, and L
u
into the cover
o
on the leg.
Adjust the height of the F table guide U
q
and the F table support F
e
so that the
table top surface will become 1 mm lower than the bed top surface.
After adjustment is
finished, tighten each bolt securely.