Brother International BES-1260BC Instruction Manual - English - Page 40

Chapter 2 Preparation of Embroidery Machine 3. Pass the thread through the hole of the upper thread guide (U), wind it into the tension disk clockwise once, and place it on the spring. 4. Pass the thread through each hole of the upper thread guide (U) and the thread guide (C). 5. After passing the thread through the hole of the thread guide (U), insert the thread into the right side of the inner thread guide, and pass it through the hole of the thread take-up. 6. Bring the thread to the inner thread guide again to insert it into the hole from the upper section, then into the lower thread guide. 7. Pass the thread through the hole of the needle bar thread guide, then pass it through the needle eye, without passing it through the presser foot. s BES-1260BC 1 2 3 4 5 Needle Bar No.3,6,9,12 No.2,5,8,11 No.1,4,7,10 6 7 1. Pass the upper thread from the cotton stand through the hole of the thread guide right above each cotton stand bar from the lower side. 2. Pass the thread under the thread guide tension disk by lifting it with a finger, and then wind it onto the pulley twice. BES-960BC • BES-1260BC 45