Brother International BES-963 Instruction Manual - English - Page 28
Preparation of Embroidery Machine, Lower by 1 mm, y
View all Brother International BES-963 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Chapter 1 Preparation of Embroidery Machine For embroidering with tubular square hoop (middle position) t Pin u e w q r Lower by 1 mm y 1. Attach four hexagon socket head cap screws to each of F table parts R q, M (2 pcs) w, and L e from the back. 2. Mount the F table parts from L e in order. Insert the bent part (lower) of F table guide UN r into the guide. Insert the F table rear pin into the hole of F table stopper N t. 3. Adjust F table supports F y in height so as to make the F table parallel with the floor. 4. Tighten all hexagon socket head cap screws u firmly. 26 BES-963BC • BES-1263BC
Chapter 1
Preparation of Embroidery Machine
BES-963BC • BES-1263BC
26
1.
Attach four hexagon socket head cap screws to each of F table parts R
q
, M (2 pcs)
w
, and
L
e
from the back.
2.
Mount the F table parts from L
e
in order.
Insert the bent part (lower) of F table guide UN
r
into the guide.
Insert the F table rear pin into the hole of F table stopper N
t
.
3.
Adjust F table supports F
y
in height so as to make the F table parallel with the floor.
4.
Tighten all hexagon socket head cap screws
u
firmly.
r
y
Lower by 1 mm
Pin
u
t
q
w
e
For embroidering with tubular square hoop (middle position)