Brother International BES-963 Instruction Manual - English - Page 43
to the right and left sides at the front., Attach one each of square nut M6
View all Brother International BES-963 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Holder base (optional) Chapter 1 Preparation of Embroidery Machine o y t i y u w o q w !2 !0 r Felt Table i Do not remove these screws. e !3 q e !1 1mm 1mm !3 Attaching the holder base frame 1. Set the table. (Refer to "3-4 Mounting of Table" (Page 25) for details.) 2. Insert the frame connecting plate F r into the holder base frame LN q, holder base frame CN w, and holder base frame RN e, using bolts and washers. 3. Remove four bolts y from the front of X-feed frame t. Attach one each of square nut M6 u to the right and left sides at the front. At the rear of the frame, attach three each of square nuts M6 u to the right and left sides. 4. Put frame connecting plates RN i and LN o on X-feed frame t. Fix them with bolts and washers. 5. Check that the clearance between the table and the mounted holder base frame C assembly w is even when viewed from the machine front. [Adjustment] Loosen three bolts of the F table support F !0 and move it in the direction of the arrow for adjustment. BES-963BC • BES-1263BC 41