Brother International BES-963 Instruction Manual - English - Page 44
Adjustment], Loosen the right and left bolts of the F table guide UN
View all Brother International BES-963 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Chapter 1 Preparation of Embroidery Machine 6. Check that the clearance between the Y-axis cover !1 and the mounted holder base frames LN q and RN e is even when viewed from the right and left sides. [Adjustment] Loosen the right and left bolts of the F table guide UN !2 and move it in the direction of arrow for adjustment. 7. Tighten each bolt securely after adjustment is finished. 8. If removing a holder base frame for frame replacement, etc., remove screw !3. Keep the frame connecting plate attached to the X-feed frame. Attaching the holder base 1. Mount the holder base mounting frame e on the X-axis feed frame q and holder base frame C w, using three clamp screws. 2. When the mounting pitch of the holder base is 370 mm, mount the holder base horizontally to the holder base mounting frames e using the thumb bolts r. q r e w 42 BES-963BC • BES-1263BC