Brother International CE-5500/CE-5500PRW Operation Manual - Page 59
Maintenance
View all Brother International CE-5500/CE-5500PRW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
MAINTENANCE Simple sewing machine maintenance operations are described below. Restrictions on oiling In order to prevent damaging this machine, it must not be oiled by the user. This machine was manufactured with the necessary amount of oil applied to ensure correct operation, making periodic oiling unnecessary. If problems occur, such as difficulty turning the handwheel or an unusual noise, immediately stop using the machine, and contact your authorized dealer or the nearest authorized service center. Precautions on storing the machine Do not store the machine in any of the locations described below, otherwise damage to the machine may result, for example, rust caused by condensation. • Exposed to extremely high temperatures • Exposed to extremely low temperatures • Exposed to extreme temperature changes • Exposed to high humidity or steam • Near a flame, heater or air conditioner • Outdoors or exposed to direct sunlight • Exposed to extremely dusty or oily environments Note ● In order to extend the life of this machine, periodically turn it on and use it. Storing this machine for an extended period of time without using it may reduce its efficiency. Cleaning the machine surface If the surface of the machine is dirty, lightly soak a cloth in neutral detergent, squeeze it out firmly, and then wipe the surface of the machine. After cleaning it once with a wet cloth, wipe it again with a dry cloth. CAUTION ● Unplug the power supply cord before cleaning the machine, otherwise injuries or an electric shock may occur. Cleaning the race Sewing performance will suffer if dust collects in the race therefore, it should be cleaned periodically. Switch the machine off and unplug it. a CAUTION ● Make sure you unplug the machine before you clean it. Otherwise, you may get an electric shock or be injured. Raise the needle and the presser foot. b Loosen the presser-foot screw and the needle c clamp screw to remove the presser-foot holder and the needle. Slide the needle plate cover release toward you d to remove the needle plate cover. 4 a Needle plate cover b Needle plate cover release Remove the bobbin case. e Grasp the bobbin case, and then pull it out. a Bobbin case Use the cleaning brush or a vacuum cleaner to f remove any dust from the race and its surrounding area. a Cleaning brush b Race Note ● Do not put oil on the race. 57