Brother International Innov-is 40e Operation Manual - Page 104
List of symptoms
View all Brother International Innov-is 40e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
APPENDIX List of symptoms Symptom The sewing machine does not operate. The needle breaks. Probable Cause Remedy Reference The plug of the power cord is not inserted into an electrical outlet. Insert the plug of the power cord into a household electrical outlet. page 14 The machine is not turned on. Turn on the machine. page 14 The bobbin winder shaft is moved to Slide the bobbin winder shaft to the the right. left. page 17 The presser foot lever is raised. Lower the presser foot lever. page 42 A stitch other than the buttonhole or bar tack stitch was selected and the start/stop button was pressed while Raise the buttonhole lever. - the buttonhole lever is lowered. The buttonhole or bar tack stitch was selected and the start/stop button was pressed while the buttonhole lever is Pull down the buttonhole lever. raised. page 60 The start/stop button was pressed, even though the foot controller is connected. Do not use the start/stop button when the foot controller is connected. To use the start/stop button, disconnect page 42 the foot controller. The needle is incorrectly installed. Correctly install the needle. page 29 The needle clamp screw is loose. Use the screwdriver to firmly tighten the screw. page 30 The needle is bent or blunt. Replace the needle with a new one. page 29 The combination of fabric, thread and needle is incorrect. Select a thread and needle that are appropriate for the type of fabric being sewn. page 28 The appropriate presser foot for the Attach the presser foot that is type of stitch that you wish to sew is appropriate for the type of stitch that page 86 not used. you wish to sew. The upper thread tension is too tight. Loosen the upper thread tension. page 47 The fabric is pulled too much. Lightly guide the fabric. - The area around the hole in the needle plate is scratched. Replace the needle plate. Contact your dealer or the nearest - authorized service center. The area around the hole in the presser foot is scratched. Replace the presser foot. Contact your dealer or the nearest - authorized service center. The bobbin case is scratched. Replace the bobbin case. Contact your dealer or the nearest - authorized service center. A bobbin designed specifically for this machine is not used. Bobbins from older models, which have a different thickness, will not work properly. Only use a bobbin designed specifically for this machine. page 15 102