Brother International Innov-is 40e Operation Manual - Page 31
Checking the needle, Replacing the needle
View all Brother International Innov-is 40e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Checking the needle Replacing the needle Sewing with a bent needle is extremely dangerous Replace the needle as described below. Use the since the needle may break while the machine is screwdriver and a correct needle, as described in being operated. Before using the needle, place the flat side of the "Checking the needle". 1 needle on a flat surface and check that the distance between the needle and the flat surface is even. Press (needle position button) once or a twice to raise the needle. a b a Flat side b Needle type marking a Needle position button Turn off the sewing machine. b a a Flat surface If the distance between the needle and the flat surface is not even, the needle is bent. Do not use a bent needle. a a Flat surface CAUTION ● Before replacing the needle, be sure to turn off the sewing machine, otherwise injuries may occur if the start/stop button is accidentally pressed and the machine starts sewing. Lower the presser foot lever. c a a Presser foot lever CAUTION ● Before replacing the needle, place fabric or paper under the presser foot to prevent the needle from falling into the hole in the needle plate. 29