Brother International Innov-is 40e Operation Manual - Page 20
Installing the bobbin
View all Brother International Innov-is 40e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
GETTING READY Memo ● When the sewing machine is started or the handwheel is turned after winding the thread around the bobbin, the machine will make a clicking sound; this is not a malfunction. ● The needle cannot move (sewing is not possible) while the bobbin winder shaft is moved to the right. Installing the bobbin Install the bobbin wound with thread. Press (needle position button) once or a twice to raise the needle, and then raise the presser foot lever. a Needle position button Turn off the sewing machine (set it to " "). b CAUTION ● Use a bobbin that has been correctly wound, otherwise the needle may break or the thread tension will be incorrect. Slide the latch on the right side of the bobbin c cover to the right, and then remove the bobbin cover. a b ● The bobbin was designed specifically for this sewing machine. If bobbins from other models are used, the machine will not operate correctly. Use only the included bobbin or bobbins of the same type (part code: SA156, SFB (XA5539-151)). c a b a This model b Other model c 11.5 mm (7/16 inch) (actual size) ● Before installing the bobbin or replacing the needle, be sure to turn off the sewing machine, otherwise injuries may occur if the start/stop button is accidentally pressed and the machine starts sewing. a Bobbin cover b Latch Insert the bobbin with your right hand so that d the end of the thread is on the left, and then, after pulling the thread firmly around the tab with your left hand as shown, lightly pull the thread to guide it through the slit. a Tab 18