Brother International Innov-is 40e Operation Manual - Page 69
of the pin of zipper foot I.
View all Brother International Innov-is 40e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Sew the zipper to the piece of fabric with the i extra 3 mm (1/8 inch), starting from the base of the zipper. Attach the presser foot holder to the other side l of the pin of zipper foot "I". If the presser foot holder was attached to the right side of the pin in step h, change it to the left side of the pin. a I b CAUTION a Left side of the pin b Needle drop point ● When sewing, be sure that the needle does not touch the zipper, otherwise the needle • For details, refer to "Replacing the presser foot" (page 31). 3 may bend or break. When you are about 5 cm (2 inches) from the j end of the zipper, stop the sewing machine with the needle down (in the fabric), raise the presser foot lever, and then open the zipper Topstitch along the zipper. m Sew reverse stitches at the end of the zipper opening and align the zipper teeth with the side of the presser foot. c and continue sewing. b d a e Close the zipper, turn over the fabric, and then k baste the other side of the zipper to the fabric. a a Basting stitching a Right side of fabric b End of zipper opening c Reverse stitching d Beginning of stitching e Basting stitching When you are about 5 cm (2 inches) from the n end of the zipper, stop the sewing machine with the needle down (in the fabric), and then raise the presser foot lever. Remove the basting stitching, open the zipper, o and then continue sewing. 67